Pioneer XW-NAC1-K, Руководство по эксплуатации

Страница: 15 / 72

Bluetooth ® AUDIO for Wireless Enjoyment of Music 04
15
En
English
Français
Español
Setting the PIN code
Set this unit’s PIN code to the same setting as
that for the
Bluetooth
wireless technology
device used. Supported PIN code setting
values include 0000, 1234 or 8888.
• Default setting: 0000
1 Press BT A.
When the
Bluetooth
wireless technology device
is not connected, the
BT AUDIO
indicator
flashes. If the
Bluetooth
wireless technology
device is connected, disconnect it.
2 When the BT AUDIO indicator flashes,
press and hold VOLUME – on the top panel,
and then press and hold
 STANDBY/ON for
three seconds.
The
SHUFFLE
2
indicator will flash, and the PIN
code will be changed. The number of flashes
corresponds to the newly set PIN code as
follows:
• 1 flash: 0000
• 2 flashes: 1234
• 3 flashes: 8888
Repeat step 2 until the PIN code is reset to the
value desired.
These settings are preserved in memory even
when the power is turned OFF. When resetting
the PIN code, turn the power ON, and perform
step 2 without any unit connected.
Pairing this unit and Bluetooth
wireless technology device
“Pairing” must be done before you start
playback of
Bluetooth
wireless technology
content using
Bluetooth
AUDIO. Make sure to
perform pairing first time you operate the
system or any time pairing data is cleared.
“Pairing” is the step necessary to register
Bluetooth
wireless technology device to enable
Bluetooth
communications.
1
For more details,
see also the operating instructions of your
Bluetooth
wireless technology device.
1 Press BT A.
When the
Bluetooth
wireless technology device
is not connected, the
BT AUDIO
indicator
flashes. If the
Bluetooth
wireless technology
device is connected, disconnect it.
2 When the BT AUDIO indicator flashes,
press

.
The
BT AUDIO
indicator will flash fast, and the
unit will enter the pairing standby mode.
3 Switch on the
Bluetooth
wireless
technology device that you want to perform
pairing with, place the device within 1 meter
of the system, and set it to the pairing mode.
Pairing begins.
4 Check to see that the Bluetooth AUDIO is
detected by the Bluetooth wireless
technology device.
The
BT AUDIO
indicator lights when
Bluetooth
wireless technology device is connected.
STANDBY/ON
SLEEP VOLUME
a
INPUT
SELECTOR
b a
Note
1 • Pairing is required when you first use Bluetooth wireless technology device and this unit.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
XW-NAC1_CUXZTSM.book 15 ページ ２０１０年３月１６日 火曜日 午後２時４分