87
XV-HTD1
1
Remove the Bonnet (Screws
×
7)
3
Power ON
4
Tray Open (
0
OPEN/CLOSE)
5
Pull out the power cord from the outlet.
6
Push the Tray by hand. (about 5 cm)
7
Bring an extra flexible cable
close to the rear side.
8
Disconnect the flexible cable.
9
9
9
Unhook
×
2
Pull out the tray
while pressing the two hooks ( ).
When Tray Cannot Pull Out
Tray cannot pull out that is not at a position of home position.
(When two hooks ( ) hide under the Rotary Tray
and can not pull out the tray.)
In that case, set the tray in the following procedures.
Note :
Do not need to match with Disc No. (1 to 5)
when returns the tray.
Detect it automatically.
Set the tray to the position
that can see a hole of the center.
2
Remove the Tray Cap
Remove the Front Panel Section (Refer to " FRONT PANEL SECTION")
Unhook
TRSB Assy
CN12
Tray Section
Note :
The Traverse mechanism being
an unclamp (=down) state.
Remove
Disassembly
9
Unhook
9
8
7
6
1
Tighten
Rotary Tray
3
2
TRAVERSE MECHANISM ASSY-S
10
10
Содержание XV-HTD1
