Getting started
04
12
En
Auto Setup
If the access point has an automatic connection button, you
can connect without entering a password.
1
Press MENU on the remote control.
2
Press
/
to select “Wi-Fi Setting”, and
press ENTER.
3
Press
/
to select “Auto Setup”, then
press ENTER.
4
Press the automatic setting button of the
access point to be connected.
“Connected” is displayed when the connection is established
and
lights.
General control
Input function
When the
INPUT
on main unit is pressed, the current
function will change to different mode. Press the
INPUT
repeatedly to select desired function.
Display brightness control
Press
DIMMER
to dims the display brightness. The
brightness can be controlled in four steps.
Volume auto set-in
If you turn off and on the main unit with the volume set to 31
or higher, the volume starts at 30 and sets in to the last set
level.
Volume control
Turn the volume knob towards
VOLUME
(on main unit) or
press
VOL +/–
(on remote control) to increase or decrease
the volume.
CAUTION
• The sound level at a given volume setting depends on
speaker efficiency, location, and various other factors.
It is advisable to avoid exposure to high volume levels.
Do not turn the volume on to full at switch on. Listen to
music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
Muting
The volume is muted temporarily when pressing the
on
the remote control. Press again to restore the volume.
CD
Bluetooth
TuneIn
Spotify
DAB
Audio In
USB
FM
SN29402598_X-CM66D_En.book 12 ページ ２０１６年８月２日 火曜日 午後４時８分
