Using the tuner
07
38
En
2
Press TUNER EDIT.
The display shows
PRESET
, then a blinking
MEM
and station preset.
3
Press PRESET
/
to select the station
preset you want.
You can also use the number buttons.
4
Press ENTER.
After pressing
ENTER
, the preset number stop
blinking and the receiver stores the station.
Listening to station presets
You will need to have some presets stored to do
this. See
Saving station presets
on page 37 if
you haven’t done this already.
•
Press PRESET
/
to select the station
preset you want.
• You can also use the number buttons on
the remote control to recall the station
preset.
Naming preset stations
For easier identification, you can name all of
your preset stations.
1
Choose the station preset you want to
name.
See
Listening to station presets
above for how
to do this.
2
Press TUNER EDIT twice.
The cursor at the first character position is
blinking on the display.
3
Input the name you want.
Choose a name up to eight characters long.
• Use the
PRESET
/
buttons to select
character position.
• Use the
TUNE
/
buttons to select
characters.
• The name is stored when
ENTER
is
pressed.
Tip
• To erase a station name, follow steps 1 and
2, and press
ENTER
while the display is
blank. Press
TUNER EDIT
while the display
is blank, to keep the previous name.
• Once you have named a station preset,
Press
DISPLAY
to show the name. When
you want to return to the frequency display,
press
DISPLAY
several times to show the
frequency.
Changing the frequency step
If you find that you can’t tune into stations
successfully, the frequency step may not be
suitable for your country/region. Here’s how to
switch the setting:
1
Switch the receiver into standby.
2
While holding down the ‘TUNE –’ button,
press and hold the
STANDBY/ON button
for about two seconds.
The channel tuning step alternates between
10K STEP
and
9K STEP
each time you do this.
VSX-RS320_DWXCN.book 38 ページ ２０１０年４月２日 金曜日 午後５時４６分
