Pioneer SX-SW77, Руководство по обслуживанию

Страница: 43 / 72

SX-SW77
43
5 6 7 8
5 6
7
8
C
D
F
A
B
E
7.1.2 SPECIFICATIONS OF SPEAKER SETUP
1. Overview
Several types of speakers are planned to be used with this product, and according to speaker type, the sound-quality
parameters to be sent to the Digital Amplifier section are different. Since the parameters for the planned speaker types have
been written in the EEPROM, by simply selecting the speaker type, as shown below, speaker setting is completed.
2. How to select the settings
1. While holding the VOL+ and STANDBY/ON keys on the Display unit pressed, connect the power cord to the wall outlet.
Note: If the power cord was disconnected immediately before, be sure to wait at least one minute before turning on the
power in this way. Otherwise, the unit may not operate properly.
Or, during Standby mode, hold the VOL+ and STANDBY/ON keys pressed for 3 seconds.
2. The power comes on; then the following indication appears.
3. Press the key corresponding to the speaker to be used to determine the setting. The power will automatically be turned off.
3. How to confirm the speaker setting
1. While holding the AUDIO INPUT and STANDBY/ON keys on the Display unit pressed, connect the power cord to the wall
outlet.
Note: If the power cord was disconnected immediately before, be sure to wait at least one minute before turning on the
power in this way. Otherwise, the unit may not operate properly.
Or, during Standby mode, hold the AUDIO INPUT and STANDBY/ON keys pressed for 3 seconds.
2. Enter Service/Test mode.
3. Hold the AUDIO INPUT key pressed for 8 seconds.
4. The setting is displayed.
5. If no setting has been written in the EEPROM, "UNKNOWN" is displayed. In this case, the unit will operate in the same way
as if "REGULAR 1" (satellite) were set.
4. Error indication
When the unit is turned on without any speaker setting, a warning "NO SPTYP" will be displayed. Even with this warning
displayed, all key operation is possible. After a key operation, the display will return to this warning indication.
R E G U L A R 1
T A L L S P
N X T S P
R E G U L A R 2
A V
G A T E
N O S P T Y P
S P . T Y P E
T A L L S P
U N K N O W N
: Flashing
Note: Be sure to select the setting corresponding to the model number of the speaker. (See the table below.)
VOL- key
VOL+ key
AUDIO INPUT key
SURROUND key
STANDBY/ON key
Destination Model Number Speaker Remarks Speaker setting
Europe SX-SW55/WYXCN, /WVXCN
SX-SW77/WYXCN, /WVXCN SMALL1
TALL REGULAR1
TALL
North America SX-SW950/KUXCN NXT NXT
Japan SX-06SW/JJXCN
SX-E230SW/JJXCN AV GATE
TALL AV rack with SP AV GATE
TALL
General SX-SW100/TDLPWXCN SMALL2
TALL REGULAR2
REGULAR2
China SX-SW100/NAXCN TALL TALL