4
Part Names
Part Names
Front Panel
1.
Í
STANDBY/ON button
2. SPEAKERS A/B button: Select the terminals to output audio from between SPEAKERS
A/B.
3. DIRECT button: Switches to the DIRECT mode which outputs pure sound as it was
intended.
4. Display (P5)
5. Remote control sensor: Receives signals from the remote controller.
0
The signal range of the remote controller is within about 16
y
/5 m, at an angle of 20° on
the perpendicular axis and 30° to either side.
6. Bluetooth indicator: Lights when the unit is connected by BLUETOOTH. It will flash during
pairing or if the connection is not correct.
7. MEMORY button: Used to register AM/FM radio stations (P15).
8. TUNING/PRESET button: Switch between the TUNING mode, where you select a
frequency to tune to a station, and the PRESET mode, where you select a preset station.
9. VOLUME
10.PHONES jack: Connect stereo headphones with a standard plug (Ø1/4
z
/6.3 mm).
11. Input Selector buttons: Switches the input to be played.
12.TONE button: Switches to the TONE mode which enables BASS and TREBLE. After
switching to the TONE mode, press again to see the settings for "Bass", "Treble", and
"P.BASS" with each press.
13.
buttons: Used to tune to AM/FM stations, select preset numbers, and to
adjust the sound quality.
14.BALANCE button: Adjusts the balance of the sounds output from the left and right
speakers (P17).
> Before Start
> Part Names
> Install
> Playback
Setup | Others
SN29403247_SX-10AE_En_1707XX.book 4 ページ ２０１７年７月１９日 水曜日 午後１時５９分
