Pioneer Super Tuner IIID AVIC-F900BT, Руководство по установке

Страница: 6 / 63

Before installing this
product
!
This product is for vehicles with a 12-volt
battery and negative earthing. Check the
battery voltage of your vehicle before instal-
lation.
!
To avoid shorts in the electrical system, be
sure to disconnect the (
–
) battery cable be-
fore beginning installation.
To prevent damage
WARNING
!
When replacing the fuse, be sure to only
use a fuse of the rating prescribed on the
fuse holder.
!
When disconnecting a connector, pull the
connector itself. Do not pull the lead, as
you may pull it out of the connector.
!
This product cannot be installed in a vehi-
cle without ACC (accessory) position on
the ignition switch.
ACC ON
S
TA
RT
O
FF
ON
S
TA
RT
O
FF
ACC position No ACC position
!
To avoid short-circuiting, cover the discon-
nected lead with insulating tape. It is espe-
cially important to insulate all unused
speaker leads, which if left uncovered may
cause a short circuit.
!
Attach the connectors of the same colour
to the corresponding coloured port, i.e.,
blue connector to the blue port, black to
black, etc.
!
Refer to the owner
’
s manual for details on
connecting the power amp and other units,
then make connections accordingly.
!
Since a unique BPTL circuit is employed,
do not directly earth the
*
side of the
speaker lead or connect the
*
sides of the
speaker leads together. Be sure to connect
the
*
side of the speaker lead to the
*
side of the speaker lead on this navigation
system.
!
If the RCA pin jack on this product will not
be used, do not remove the caps attached
to the end of the connector.
!
Never connect speakers with an output rat-
ing of less than 50 W channel or impe-
dance outside of the 4 ohms to 8 ohms
specifications to your navigation system.
Connecting speakers with output and/or
impedance values other than those noted
here may result in the speakers catching
fire, emitting smoke, or becoming da-
maged.
Notice for the blue lead
!
A signal is output through the blue lead to
control the aerial of your vehicle. The tim-
ing varies depending on the setting. (For
more detailed information on changing
[
Ant CTRL
] mode, refer to
“
Operation Man-
ual
”
.)
!
When [
Ant CTRL
] mode is set to [
Radio
],
the vehicle
’
s aerial can be stowed or turned
off by following the instructions below.
Connecting the System
Engb
6
Section
03