Note
• Check all connections and systems before final
installation.
• Do not use unauthorized parts. The use of
unauthorized parts may cause malfunctions.
• Consult with your dealer if installation requires
drilling of holes or other modifications of the
vehicle.
• Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result of
a sudden stop.
• Do not install the display where it may (i) obstruct
the driver’s vision, (ii) impair the performance of
any of the vehicle’s operating systems or safety
features, including air bags, hazard lamp buttons or
(iii) impair the driver’s ability to safely operate the
vehicle.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
• Optimum performance is obtained when the unit is
installed at an angle of less than 30°.
Before installing this unit
•
Remove the holder.
Loosen the screws (3 mm × 6 mm) to remove
the holder.
Installation with the holder
and side bracket
1. Install the holder into the dashboard.
After inserting the holder into the dashboard,
select and bend the tabs appropriate to the
thickness of the dashboard material. (Install
this unit as firmly as possible using the top and
bottom tabs. To secure this unit, bend the tabs
90 degrees.)
2. Install this unit and fasten the screws.
Rubber bush
Double-ended screw
Screw (3 mm × 6 mm)
Dashboard
Screw (3 mm × 6 mm)
Holder
Dashboard
Holder
3. Attach the trim ring.
Installation using the screw
holes on the side of the unit
1. Remove the side brackets.
2. Fastening the unit to the factory
radio-mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket, and
tighten the screws at 3 or 4 locations on each
side.
Note
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If this
happens, use the supplied frame to fill the gap.
Trim ring
Side bracket
Screw for fixing the side
bracket (5 mm × 8 mm)
Factory radio
mounting bracket
If the pawl gets in the way,
bend it down.
Dashboard or console
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this unit.
Installation
Installation
