Pioneer SGY-PM930H, Руководство пользователя

Страница: 18 / 242

18
EN
G
et
tin
g S
ta
rte
d
Switching to the pedaling monitor mode
product on the data field screen and
select [Bike] - [Sensors]. The display
on the mode switching completion
screen is as follows depending on the
status.
• [Success]
Mode is switched.
• [Timeout]
Sensor is not found.
• [Cancel]
Cancel is pressed.
• [Low Battery]
The battery is almost empty.
• Timeout: Communication status is
likely to be poor. Sensor information
cannot be received properly. Make
sure that the sensor you are pairing
is activated, then bring the SGX-
CA600 closer to the sensor and
perform the pairing operation again.
Pairing with the sensor may not be
possible due to interference in the
same frequency band. If “Timeout”
is displayed even by operating
after moving SGX-CA600 closer to
the sensor and pairing with it, try
again someplace where there is no
interference from microwaves, radio
waves, or wireless equipment.
• Low Battery: The battery is almost
empty. Remove the battery and
replace with a new one. For how
to install/remove batteries, refer to
Page 13.
If you do not add the sensor in the
sensor list, the SGX-CA600 will not
pair with the sensor.
You can add the sensor in the sensor
list later, using the [Sensors] menu.
When the mode is switched, the
LEDs of the sensors light green for 10
seconds.
Add in the sensor list of SGX-
CA600
When it is added in the sensor list,
it pairs with SGX-CA600. Hereafter,
whenever the sensor is started, it will
automatically pair with SGX-CA600.
To confirm the sensor list, press
the [Menu] button on the left of the