13
S-W205, S-W105
REAR SECTION
100 Hz …For middle-sized speaker
(woofer diameter: 4 to 10 inch)
200 Hz …For small-sized speaker
(woofer diameter: 5 inch or less)
6
Subwoofer input terminals
(SPEAKER LEVEL INPUT)
Connect the speaker output terminals of amplifier or receiver
to these terminals with the accessory two parallel-wire cords.
7
Speaker output terminals
(SPEAKER LEVEL OUTPUT)
Connect the speaker input terminals to these terminals with
the two parallel-wire cords. When the SPEAKER LEVEL IN-
PUT is in use.
8
Subwoofer input terminal
(LINE LEVEL INPUT)
Connect SUBWOOFER output terminal of the amplifier or
receiver to this terminal with the accessory RCA cord.
9
Subwoofer output terminal
(LINE LEVEL OUTPUT)
Used for connecting an additional subwoofer to the system.
Connect this terminal to the SUBWOOFER INPUT terminal
of another subwoofer.
1
POWER/STANDBY indicator
GREEN: Power is being supplied.
RED:
AUTO POWER OFF function is operating.
2
AUTO POWER switch
AUTO POWER OFF ON/OFF switch.
ON: AUTO POWER OFF function is operating.
OFF: Normal power supply conditions
3
Subwoofer LEVEL knob
Volume of subwoofer is adjusted with this knob. Turn this
knob clockwise to raise the level.
÷
Starting with “MIN“, turn this knob and raise the volume
slowly. If the unit is turned on with the volume set too high,
it could cause hearing and/or speaker damage. Do not
turn the volume up excessively high. The low frequency
sound is apt to be raised too high since it is less disturbing
and harder to detect than high frequencies. Caution must
be taken here since the amplifier and speaker of the S-
W205, S-W105 will be clipped when the output of the am-
plifier or receiver is increased with the subwoofer level set
to “MAX“.
4
PHASE selector switch
This switch changes over the subwoofer phase [NORM (in-
phase), REV (opposite phase)] for the combination speak-
ers. Set this switch to suit your choice of bass, according to
the location of the subwoofer.
5
CROSSOVER frequency control knob
Select the position according to the woofer level of the
speaker to be combined.
50 Hz … For large-sized speaker
(woofer diameter: 8 inch or more)
Illustration shows model S-W205.
1
5
7 8
3
4
6
2
9
If the output of the amplifier (receiver) connected to this
unit is high or if the output has a low range boosted by the
Bass control, Bass boost, or other means, there may be
some sound distortion even if the level of the unit is low-
ered. In this case, lower the output level (Volume, Bass
control, Bass boost) on the amplifier (or receiver) side.
6. PANEL FACILITIES
POWER ON
GREEN
STAND BY
RED
SPEAKER LEVEL
INPUT
AUTO
POWER
ON OF
+
R
–
–
L
+
+
R
–
–
L
+
SPEAKER LEVEL OUTPUT
LINE LEVEL
INPUT
LEVEL
PHASE
REV NORM
CROSSOVER
FREQUENCY
Hz
100
150
200
50
60
80
MIN
MAX
OUTPUT
