Getting started
01
6
En
Chapter 1
Getting started
Home theater sound setup
Depending on the size and characteristics of
your room, you can place your speakers in one
of two ways using this system:
1
•
Standard surround 5-spot setup
– This is
a standard multichannel surround sound
speaker setup for optimal 5.1 channel
home theater sound.
•
Front surround 3-spot setup
– This setup
is ideal when rear surround speaker
placement isn't possible or you want to
avoid running long speaker cables in your
listening area. Use this setup together with
the Front Surround modes to take
advantage of wall and ceiling reflections
for a very realistic surround effect.
After placing your speakers, complete
Setting
the channel levels
below then refer to
Speakers
settings
on page 22 to complete your surround
sound setup.
Setting the channel levels
Set the relative channel levels from your main
listening position.
2
1
Press
SHIFT+TEST TONE
.
The test tone is output in the following order
(from the speakers active in the current
listening mode):
•
L
– Front left speaker
•
C
– Center speaker
•
R
– Front right speaker
•
SR
– Right surround speaker
•
SL
– Left surround speaker
•
SW
– Subwoofer
3
2
Use the /– button to adjust
the volume to an appropriate level.
3
Use the
/
(cursor up/down) buttons
to adjust the speaker levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
4
When you’re done, press ENTER to exit
test tone setup.
Note
1 See
About the listening modes
on page 11 for more on using the different listening modes with each speaker setup.
Front left
Surround
left
Listening position
Center
Subwoofer
Front right
Surround
right
Front
left
Front
right
Surround
left
Surround
right
Listening position
Center
Subwoofer
2 • This is only available when
DVD/CD
is selected and playback is stopped. Also make sure headphones are unplugged.
• The speaker volume can be adjusted while listening to any sound source you want: Press
SHIFT+SYSTEM SETUP
, use the
/
(cursor left/right) buttons to select the channel level setting, then press
ENTER
. Use
/
(cursor up/down) to adjust the
channel levels;
/
(cursor left/right) to move to the next channel. Press
ENTER
when you’re finished.
3 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
XV-DV250-350.book 6 ページ ２００５年１月３０日 日曜日 午後５時５４分
