Pioneer S-31-LR-K, Руководство пользователя

Страница: 3 / 58

3
En
English
How to install
Choosing where to place the speaker systems
• Sounds played through speaker systems are easily affected in
subtle ways by the conditions in the listening space.
• For best sound, choose a solid floor upon which to place the
speakers, and position the speakers as shown below. The level
of low sounds can be adjusted by moving the speakers closer
to or further from the wall. Adjust the speakers so that they are
equidistant from their respective side walls to assure balanced
sound.
• Place the left and right speakers equal distances from your
listening position for good stereo sound. Use speaker cords of
the same length for each speaker.
• So far as possible, place the front left and front right speakers
on the same plane as the TV screen.
• To achieve optimum surround sound, you should place the TV
between the left and right speakers, with the speakers
pointing at a 50 to 60 degree angle toward the listening
position.
• If the room has a lot of reverberation, we recommend hanging
heavy fabric on the walls, and/or putting a carpet on the floor
to damp the sound. For best results, cover walls completely.
• Pioneer assumes no liability whatsoever for damages
resulting from assembly, improper mounting, insufficient
reinforcement, misuse of the product, acts of nature, etc.
• Since these speaker systems are quite heavy, do not install
them in unstable locations; a falling speaker could result in
damage or dangerous personal injury.
• When installing these speaker systems, be sure to provide
positive measures against tipping or falling, since accidental
falls due to earthquakes or other causes could result in injury.
Applying non skid pads
The use of non skid pads is recommended depending on the
installation location. Apply the pads to the four corners of the side
of the speaker which will be on the bottom. Note that depending
on the location, the pads may not provide fully sufficient traction
to prevent slipping, so care should be taken not to install the
speakers in conditions where they may be prone to slide.
Mounting the Fall-Prevention Fastener
• Using the included screw, tightly secure the metal catch to the
backside of the speaker.
• Pass a commercially-available reinforced string through the
metal catch to securely support the speaker to the wall. Be
sure that the wall to which you fasten the speaker is strong
enough to support the weight of the speaker. After fastening
the speaker, make sure that it does not fall over.
• The speaker can incur damage in the event of a fall.
• Do not attach the metal catch directly to the wall. It should
only be used in conjunction with reinforced string to prevent
the speaker from falling.
• Pass two reinforced strings through the metal catch, and
fasten the speaker to the wall as shown above.
50 to 60
20 cm
(7
7 /
8
in.)
50 cm
(19
11 /
16
in.)
Non skid pads
Metal catch
Reinforced strings
Backside of speaker
S-31_En.fm 3 ページ ２００９年７月２９日 水曜日 午後３時４５分