PDP-506PE
75
5
6
7
8
5
6
7
8
C
D
F
A
B
E
7.1.4 OPERATION WHEN THE MEDIA RECEIVER IS NOT CONNECTED
RED
RED
RED
To operate the panel without the Media Receiver, there are the following two ways:
1. Operation-without-the-Media-Receiver mode
Input the "SYS S00" RS232C command. The status of the LEDs changes to that in normal operation mode.
Note:
Turning the AC switch to OFF then ON also maintains this mode. However, once the unit is connected with the Media Receiver using
the System cable, this mode is automatically canceled.
2. DVI mode
Turn the unit on while DVI SG signals are being input with only the DVI connecter connected. After a warning is displayed for about 5
seconds, the unit is ready to display the screen of the input signal. (Blue LED lit)
Notes:
• Although the output from XGA (43 inch) and WXGA (50 inch) can be input to the unit, this is not a mode open to general users.
(With some signals, errors such as power-down may occur.)
As the connection conditions of the system cables (MDR cable, DVI cable) are usually detected, if no connection, such as cable
disconnection, is detected, a warning indication (alternate flashing of the red and blue areas) is displayed on the mask screen, and the red
and green LEDs flash alternately. Then after about 30 seconds, the power is automatically turned off.
Alternate flashing at intervals of about 1 second
Blue
Blue
