21
En
Watching TV
06
En
gl
is
h
Watching TV
Unless you set up TV channels that you can watch under the
current conditions, you cannot tune in those channels. For the
procedure, see “Setting up TV channels automatically” on page
27.
Turning on/ off the power
NOTE
• When the Media Receiver is plugged into a power outlet, it is
placed into the standby mode; the STANDBY indicator on its
front panel should flash red. The Media Receiver stays in the
standby mode unless it is unplugged from the power outlet.
To turn on the system, press
POWER
on the Plasma Display.
• The POWER ON indicators on the Plasma Display and Media
Receiver light up in blue.
To turn off the system, press
a
on the remote control unit or
STANDBY/ON
on the Media Receiver.
• The Plasma Display and Media Receiver are placed into the
standby mode; their respective STANDBY indicators light up
in red.
• You can then turn on the system again by pressing
a
or
0
to
9
on the remote control unit or
STANDBY/ON
on the Media
Receiver. If you press
0
on the remote control unit, images
come from the INPUT 1 source. If you press
1
to
9
, TV images
display.
You can also press
POWER
on the Plasma Display to turn off
the system. However, you cannot then turn on the system
again by pressing the buttons on the remote control unit and
Media Receiver.
NOTE
• If you are not going to use the Plasma Display System for a
long period of time, be sure to remove the power cord from
the power outlet.
• When the system is placed into the standby mode, the main
power flow is cut and the system is no longer fully
operational. A minute flow of power feeds the system to
maintain operation readiness.
Plasma Display
Media Receiver
Plasma Display/Media Receiver status indicators
The table below shows the operational status of the Plasma
Display System. You can check the current status of the system
with the indicators on the Plasma Display and Media Receiver.
For other than the above, see “Troubleshooting” on page 46.
STANDBY indicator
POWER ON indicator
POWER
button
ON
STANDBY
STANDBY/ON
PULL
OPEN
STANDBY indicator
POWER ON indicator
STANDBY/ON
Indicator Status
System Status
Plasma Display
Media Receiver
POWER ON
STANDBY
POWER ON
STANDBY
The power cords of both the Plasma Display and the Media Receiver have been
disconnected. Or, the power cord of the Plasma Display has been connected but
the
POWER
button of the Plasma Display is off.
Power to the system is on.
The system is in the standby mode.
Flashing
The power cord of the Media Receiver has been disconnected.
Flashing
Power to the Plasma Display is off. Or the power cord of the Plasma Display has
been disconnected.
PDP-506FDE.book Page 21 Wednesday, June 29, 2005 4:00 PM
