73
•
The control box is not waterproof. It must be installed inside the vehicle.
•
Find a suitable control box location. Confirm that the sensor wire length is sufficient to reach from the bumper to the control box location
before proceeding.
•
Route the sensor wires into the vehicle to the control box.
Fig 1:
•
Using the 19 mm (6/8 in.) hole saw (supplied), drill a hole in each of the 4 positions you marked in SENSOR INSTALLATION 1.
Fig 2:
•
Insert the sensors into the holes one by one.
•
Make sure the arrow direction points upward when inserting the sensor into the hole.
•
To ensure a proper fit, make sure the sensor is seated firmly into the bumper.
Profile of the bumper
CAUTION
Do not paint the sensors. Paint could impair or disable the sensor function.