24
En
Preparation
05
2
Fit the speaker to the mounting fittings in the correct direction.
• Be sure not to mount the speaker upside down.
Caution
• To avoid any damage to the speaker and/or table top stand from striking against each other, fit the speaker to the mounting fittings
while confirming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker was wrapped
between the speaker and stand.
• When the speaker mounting fittings do not fit the grooves at the rear of the speaker, adjust the speaker mounting fittings angle.
3
Tighten from back using the supplied screws (three locations).
Tighten the three screws in order
,
,
as shown in the drawing.
Front side of the
speaker
The side with the padding strip
is facing upwards.
Insert the groove on the
back of the speaker into the
speaker mounting fitting.
For illustrative purposes, the table
top stand is not presented here.
Protective
wrapping
3
1
2
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting screw
(M5 x 10 mm)
When using the
table top stand, do
not use these holes.
Caution
• If you want to move the plasma display, make
sure that you remove the speaker first. In
addition, do not move the plasma display
holding on to the mounting fittings. This can
result in injury or damage to the unit.
The screw hole at the bottom of the speaker
mounting fitting is used when the plasma
display is installed on the wall. It is not used
when installed with the stand.
Note
• If after attaching the speaker its position
needs to be adjusted horizontally or
vertically, first loosen the speaker mounting
screws, reposition and then tighten the
screws again at the appropriate position.
