Pioneer Elite SC-97, Руководство по эксплуатации

Страница: 27 / 171

27
Connecting your equipment
03
Bi-wiring your speakers
Your speakers can also be bi-wired if they support bi-amping.
! With these connections, the
Speaker System
setting makes no difference.
CAUTION
!
Don’t connect different speakers from the same terminal in this way.
! When bi-wiring as well, heed the cautions for bi-amping shown above.
%
To bi-wire a speaker, connect two speaker cords to the speaker terminal on the receiver.
Using a banana plug for the second connection is recommended.
Installing your speaker system
At the very least, front left and right speakers only are necessary. Note that your main surround speakers should
always be connected as a pair, but you can connect just one surround back speaker if you like (it must be con-
nected to the left surround back terminal).
[A] 7.2.2 channel surround system (Surround back/Top middle) connection
! If necessary, select ‘
7.2.2/5.2.2/7.2ch
’ from the
Speaker System
menu.
See Speaker system setting on page 113 to do this.
! When only connecting one surround back speaker, connect it to the SURROUND BACK L (Single) terminals.
!
In Speaker Setting , when TMd is set to Dolby Sp (Front) , Dolby Sp (Surr) , or Dolby Sp (SB) , connect the top
middle channel to Dolby Enabled Speaker.
PRE OUT
SURROUND SURR BACK T MIDDLE
(Single)
FRONT CENTER SUBWOOFER
1
2
FRONT CENTER
R
L
SURROUND
R L
SURROUND BACK
R L
TOP MIDDLE
R L
EXTRA 1 EXTRA 2
EXTRA 1
R L
(Single)
SPEAKERS
SELECTABLE
LINE LEVEL
INPUT
LINE LEVEL
INPUT
Top middle left Top middle right
Front left Front right Center Subwoofer 2 Subwoofer 1
Surround left
Surround back right Surround back left
Surround right