17
En
Preparation
05
Chapter 5
Preparation
Installing the plasma display
Location
• Avoid direct sunlight. Maintain adequate ventilation.
Note
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the unit.
Moving the plasma display
Because the plasma display is heavy, be sure to have someone
help you when moving it.
(PRO-150FD)
(PRO-110FD)
Caution
When installing on a rack, etc., hold the plasma display.
Attaching the Pioneer stand
The plasma display comes with the Pioneer table top stand. You
can also install the display on a rack by detaching the stand. The
method for attaching/detaching the stand varies depending on
the product.
Caution
• This product can be used only with the attached stand. Using
other stands can result in instability, possibly causing injury.
• The weight of a 60 inch plasma display is about 55.5 kg (122.4
lbs.) and a 50 inch about 38.8 kg (85.5 lbs.), it has no depth, and
is unstable. Therefore, at least two people must assemble and
install it.
Assembling the stand (PRO-150FD only)
1
Turn the base cover over so the underside is
facing up.
2
Insert the stand pipes into the base cover.
Insert stand pipe (R) into the side marked “R” and stand pipe
(L) into the side marked “L”.
3
Tighten the screws 1 (M5 x 10 mm: black) to
stabilize the stand pipes.
Note
• Assemble the stand with a soft sheet placed under the base
cover. If a sheet is not laid before assembly, the front surface of
the base cover may be scratched.
• Please take care when installing stand pipes (L) and (R) to
ensure that they are in the correct positions. Mistakenly
installing the stand pipes may damage the stand.
Over 50 cm
(19-11/16 inches)
Over
10 cm
(3-5/16
inches)
Stand
pipe with “R”
inscribed
Screws
➀
(M5 x 10 mm: black)
Completed
Table top stand
Sheet
Base cover
Screws
➀
(M5 x 10 mm: black)
Stand
pipe with “L”
inscribed
Front
Rear
PRO150FD.book Page 17 Tuesday, June 12, 2007 12:37 PM
