Pioneer DVR-RT300-S/UXTLCA, Руководство по обучению

Страница: 47 / 56

2-8: T BRAKE ARM/T BRAKE BAND
(Refer to Fig. 2-8-A)
1. Remove the T Brake Spring.
2. Turn the T Brake Arm clockwise and bend the hook
section to remove it.
3. Unlock the 2 supports
1
and remove the T Brake Band.
NOTE:
1. In case of the T Brake Band installation, install correctly
as Fig. 2-8-B.
2-9: S REEL/T REEL/IDLER ARM ASS'Y/IDLER
GEAR (Refer to Fig. 2-9-A)
1. Remove the S Reel and T Reel.
2. Remove the 2 Polyslider Washers
1
.
3. Remove the Idler Arm Ass'y and Idler Gear.
NOTE:
1. Take care not to damage the gears of the S Reel and T
Reel.
2. The Polyslider Washer may be remained on the back of
the reel.
3. Take care not to damage the shaft.
4. Do not touch the section "A" of S Reel and T Reel. (Use
gloves.) (Refer to Fig. 2-9-A) Do not adhere the stains
on it.
5. When you install the reel, clean the shaft and grease it
(FG-84M). (If you do not grease, noise may be heard in
FF/REW mode.)
6. After installing the reel, adjust the height of the reel.
(Refer to MECHANICAL ADJUSTMENT)
NOTE:
1. In case of the S Reel and T Reel installation, check if the
correct parts are installed. (Refer to Fig. 2-9-B)
2. In case of the Idler Arm Ass'y installation, install correctly
as Fig. 2-9-C. And also set it so that the section "B" of
Fig. 2-9-A is placed under the Main Chassis tab.
Fig. 2-8-A
Fig. 2-8-B
Fig. 2-9-A
Fig. 2-9-B
Fig. 2-9-C
1
1
1
1
T Brake Band
T Brake Band
Clutch Gear
Clutch Gear
T Brake Band
Hook Section
T Brake Arm
T Brake Arm
Big Hole
(S Reel) Small Hole
(T Reel)
T Brake Arm
T Brake Spring
(A)
(A)
(B)
T Reel
S Reel
Idler Gear
Idler Arm Assy
Idler Arm Assy
Idler Arm Assy
[OK]
[NG]
[OK]
[NG]
47