8
Preparing the Remote Control
Inserting batteries into the remote
control
1
Push down on the tab on the battery
compartment cover, and pull out in the
direction indicated by the arrow.
2
Insert batteries.
Make sure to match the plus (+) and minus
(–) polarity guides on the batteries with the marks
inside the battery compartment.
3
Close the cover.
Notes
• Do not mix old and new batteries.
• When replacing batteries, use all new batteries.
• When not using the remote control for a long period of time
(over 1 month), remove the batteries to avoid possible damage
from battery corrosion. If battery leakage occurs, wipe the
battery liquid from the battery component, then insert new
batteries.
Before Using
Checking Accessories
Please confirm that the following were received with the
player.
Audio cord
Video cord
Master-Slave control cord
Remote control unit
AA/R6P batteries
Operating instructions
(this manual)
Warranty card
(U.S. and Canadian models only)
30
°
30
°
(23 ft.)
7 m
Î
4
¢
1
¡
7
3
8
Remote control operation
When operating the remote control, point it at the remote
sensor (
Î
) located on the player’s front panel. The
remote control can be used up to 7 m (23 feet) from the
player and within a 30° angle on each side of the sensor.
Notes
• Exposing the remote sensor to direct sunlight or strong light
may cause faulty operation.
• When Master-Slave connections are made to another DV-F727
to create a 601-disc changer, only the remote sensor on the
first DV-F727 will accept signals from the remote control
(page 66).
• If the CONTROL IN jack on the player’s rear panel is connected
to the CONTROL OUT jack of another component, point the
remote control at the other component to operate the player.
Operation will not be possible when pointed at this player
(page 19).
