5
En
En
g
lis
h
WARNING
•
Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor
immediately.
•
Do not expose the battery or remote control to excessive heat such as direct sunlight or fire.
CAUTION
•
There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the
battery, replace it with the same type.
•
Do not handle or store the battery with metallic tools or objects.
•
If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a
new battery.
•
When disposing of used batteries, please comply with governmental regulations or environmental
public institutions’ rules that apply in your country/area.
Important
•
Do not store the remote control in high temperatures or direct sunlight.
•
Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator pedal.
When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the
display.
1
Press the
M.C.
dial.
The setup menu disappears after 30 seconds of no operation. If you prefer not to set
at this time, turn the
M.C.
dial to select [NO], then press to confirm.
2
Turn the
M.C.
dial to adjust the hour, then press to confirm.
The indicator moves to the minute setting automatically.
3
Turn the
M.C.
dial to adjust the minute, then press to confirm.
[QUIT] appears.
4
Turn the
M.C.
dial to select [YES], then press to confirm.
NOTES
•
You can cancel the menu setting by pressing
SRC/OFF
.
•
This setting can be made at any time. See page 11 for more details.
1
Press the
M.C.
dial to display the main menu.
2
Turn the
M.C.
dial to select [SYSTEM], then press to confirm.
Setting the clock (CLOCK SET)
Canceling the demonstration display (DEMO OFF)
3
Turn the
M.C.
dial to select [DEMO OFF], then press to confirm.
4
Turn the
M.C.
dial to select [YES], then press to confirm.
1
Press and hold
SRC
/
OFF
until the unit turns off.
2
Press the
M.C.
dial to display the main menu.
3
Turn the
M.C.
dial to select [INITIAL], then press to confirm.
4
Turn the
M.C.
dial to select an option, then press to confirm.
NOTE
The options vary depending on the unit.
The tuner frequencies on this unit are allocated for use in North America. Use in other
areas may result in poor reception.
INITIAL settings
Menu Item
Description
SP-P/O MODE
Select when there is a full-range speaker connected to the rear
speaker output leads and there is a subwoofer connected to the
RCA output.
[REAR/SUB.W]
[SUB.W/SUB.W]
Select when there is a passive subwoofer connected directly to
the rear speaker output leads and there is a subwoofer
connected to the RCA output.
[REAR/REAR]
Select when there are full-range speakers connected to the rear
speaker output leads and RCA output. If there is a full-range
speaker connected to the rear speaker output leads, and the
RCA output is not used, you may select either [REAR/SUB.W] or
[REAR/REAR].
SYSTEM RESET
Select [YES] to initialize the unit settings. The unit will be
restarted automatically.
(Some of the settings may be retained even after resetting the
unit.)
[YES], [CANCEL]
Radio
