5
En
En
g
lis
h
CAUTION
•
There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the
battery, replace it with the same type.
•
Do not handle or store the battery with metallic tools or objects.
•
If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a
new battery.
•
When disposing of used batteries, compliance with governmental regulations or environmental
institutions’ rules that apply in your country/area must be followed that pertain to any special
handling needed for disposal.
Important
•
Do not store the remote control in high temperatures or direct sunlight.
•
Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator pedal.
When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the
display.
1
Press the
M.C.
dial.
The setup menu disappears after 30 seconds of no operation. If you prefer not to set
at this time, turn the
M.C.
dial to select [NO], then press to confirm.
2
Turn the
M.C.
dial to select the options, then press to confirm.
To proceed to the next menu option, you need to confirm your selection.
3
[QUIT :YES] appears when all the settings have been made.
To return to the first item of the setup menu, turn the
M.C.
dial to select [QUIT :NO],
then press to confirm.
4
Press the
M.C.
dial to confirm the settings.
NOTES
•
You can cancel the menu setting by pressing
SRC
/
OFF
.
•
These settings can be made at any time from the SYSTEM settings (page 9) and INITIAL settings
(page 5).
1
Press the
M.C.
dial to display the main menu.
2
Turn the
M.C.
dial to select [SYSTEM], then press to confirm.
3
Turn the
M.C.
dial to select [DEMO OFF], then press to confirm.
4
Turn the
M.C.
dial to select [YES], then press to confirm.
1
Press and hold
SRC
/
OFF
until the unit turns off.
2
Press the
M.C.
dial to display the main menu.
3
Turn the
M.C.
dial to select [INITIAL], then press to confirm.
4
Turn the
M.C.
dial to select an option, then press to confirm.
Setup menu
Menu Item
Description
CLOCK SET
Set the clock.
FM STEP
Select the FM tuning step from 100 kHz or 50 kHz.
[100], [50]
MW STEP
Select the MW tuning step from 10 kHz or 9 kHz.
[10], [9]
Canceling the demonstration display (DEMO OFF)
INITIAL settings
Menu Item
Description
FM STEP
Select the FM tuning step from 100 kHz or 50 kHz.
[100], [50]
MW STEP
Select the MW tuning step from 10 kHz or 9 kHz.
[10], [9]
SP-P/O MODE
Select when there is a full-range speaker connected to the rear
speaker output leads and there is a subwoofer connected to the
RCA output.
[REAR/SUB.W]
[SUB.W/SUB.W]
Select when there is a passive subwoofer connected directly to
the rear speaker output leads and there is a subwoofer
connected to the RCA output.
[REAR/REAR]
Select when there are full-range speakers connected to the rear
speaker output leads and RCA output. If there is a full-range
speaker connected to the rear speaker output leads, and the
RCA output is not used, you may select either [REAR/SUB.W] or
[REAR/REAR].
SYSTEM RESET
Select [YES] to initialize the unit settings. The unit will be
restarted automatically.
(Some of the settings may be retained even after resetting the
unit.)
[YES], [CANCEL]
