DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 8)
Fig. 8
2. Fastening the unit to the factory radio mounting bracket.
(Fig. 9) (Fig. 10)
Select a position where the screw holes of the bracket and
the screw holes of the head unit become aligned (are fitted),
and tighten the screws at 2 places on each side. Use either
truss screws (5
×
8 mm) or flush surface screws
(5
×
9 mm), depending on the shape of the screw holes in
the bracket
.
Fig. 9
Fig. 10
11
13
12
10
Frame
Screw
Dashboard or Console
Factory radio mounting bracket
To remove the frame, extend top and
bottom of the frame outwards in
order to unlock it. (When reattaching
the frame, point the side with a
groove downwards and attach it.)
• It becomes easy to remove the
frame if the front panel is released.
Removing the unit (Fig. 6) (Fig. 7)
Fig. 6
Fig. 7
To remove the frame, extend top and
bottom of the frame outwards in
order to unlock it. (When reattaching
the frame, point the side with a
groove downwards and attach it.)
• It becomes easy to remove the
frame if the front panel is released.
Insert the supplied extraction keys
into the unit, as shown in the figure,
until they click into place. Keeping
the keys pressed against the sides of
the unit, pull the unit out.
Note:
• Before making a final installation of the unit, tem-
porarily connect the wiring to confirm that the con-
nections are correct and the system works
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifications
of the vehicle.
• Install the unit where it does not get in the driver’s
way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
• The semiconductor laser will be damaged if it
overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
• If installation angle exceeds 60° from horizontal,
the unit might not give its optimum performance.
(Fig. 3)
Fig. 3
• When installing, to ensure proper heat dispersal
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.
Fig. 4
10 cm (3-7/8 in.)
10 cm (3-7/8 in.)
Dashboard
Leave ample space
60
°
Installation
<ENGLISH>
Frame
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN Front-mount) or
“Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit
chassis). For details, refer to the following illustrated installation methods.
DIN Front-mount
Installation with the rubber bush (Fig. 5)
Fig. 5
1
182
1
182
53
53
Dashboard
Rubber bush
Screw
Holder
After inserting the holder into the
dashboard, then select the appropriate
tabs according to the thickness of the
dashboard material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
CRD4099AN 06.2.1 10:28 AM Page 5
