1 Press FUNCTION to select AUX.
Press
FUNCTION
repeatedly until
AUX
ap-
pears in the display.
2 Press
a
or
b
to turn AUX on or off.
Pressing
a
or
b
will turn
AUX
on or off and
that status will be displayed (e.g.,
AUX :ON
).
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
s headlights are turned on. You
can switch dimmer on or off.
1 Press FUNCTION to select Dimmer.
Press
FUNCTION
repeatedly until
Dimmer
ap-
pears in the display.
2 Press
a
or
b
to turn Dimmer on or off.
Pressing
a
or
b
will turn
Dimmer
on or off
and that status will be displayed (e.g.,
Dimmer :ON
).
Adjusting the brightness
You can adjust the display brightness. Initially
this mode is set to 12.
1 Press FUNCTION to select Brightness.
Press
FUNCTION
repeatedly until
Brightness
appears in the display.
2 Press
c
or
d
to adjust the brightness
level.
Each press of
c
or
d
increases or decreases
the brightness level.
0
15
is displayed as the
level is increased or decreased.
Setting the rear output and
subwoofer controller
This unit
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP :FULL
) or subwoofer
(
REAR SP :S/W
) connection. If you switch the
rear output setting to the
REAR SP :S/W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP :FULL
). When rear
output are connected to full range speakers
(when
REAR SP :FULL
is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller
s (low pass filter,
phase) built-in
PREOUT :S/W
or the auxiliary
PREOUT :FULL
.
1 Press FUNCTION to select REAR SP.
Press
FUNCTION
repeatedly until
REAR SP
ap-
pears in the display.
2 Press
a
or
b
to switch the rear output
setting.
Pressing
a
or
b
will switch between
REAR SP :FULL
(full-range speaker) and
REAR SP :S/W
(subwoofer) and that status
will be displayed.
#
When no subwoofer is connected to the rear
output, select
REAR SP :FULL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
REAR SP :S/W
.
#
When the rear output setting is
REAR SP :S/W
, you cannot change the subwoofer
controller.
3 Press
c
or
d
to switch the subwoofer
output or non fading output (full-range
RCA output).
Pressing
c
or
d
will switch between
PREOUT :S/W
and
PREOUT :FULL
and that
status will be displayed.
Initial Settings
En
33
English
Section
08
HHHHHHHHHHHHHH