Adjusting initial settings
1
Initial settings lets you perform initial set up of
different settings for this unit.
1
Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press FUNCTION and hold until the
clock appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION
repeatedly to switch be-
tween the following settings:
Clock
Warning
(warning tone)
AUX
(aux-
iliary input)
Dimmer
(dimmer)
Brightness
(brightness)
REAR SP
(rear output and sub-
woofer controller)
Telephone
(telephone)
Motion
(motion screen)
Use the following instructions to operate each
particular setting.
#
To cancel initial settings, press
BAND
.
#
You can also cancel initial settings by holding
down
FUNCTION
until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press
FUNCTION
repeatedly until clock ap-
pears in the display.
2 Press
c
or
d
to select the segment of
the clock display you wish to set.
Pressing
c
or
d
will select one segment of the
clock display:
Hour
Minute
As you select segments of the clock display
the segment selected will blink.
3 Press
a
or
b
to set the clock.
Pressing
a
will increase the selected hour or
minute. Pressing
b
will decrease the selected
hour or minute.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press FUNCTION to select Warning.
Press
FUNCTION
repeatedly until
Warning
appears in the display.
2 Press
a
or
b
to turn Warning on or off.
Pressing
a
or
b
will turn
Warning
on or off
and that status will be displayed (e.g.,
Warning :ON
).
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
Initial Settings
En
32
Section
08
HHHHHHHHHHHHHH
