Pioneer DEH-MG2037ZF, Руководство по обслуживанию

Страница: 68 / 92

68
1
2 3 4
1 2
3 4
F
E
D
C
B
A
DEH-MG2037ZF/XU/UC
Notes:
*1) Insertion/ejection error is output only when door open/close error occurs with forced eject.
*2) LIFT error is output under the following conditions:
LIFTDN --> TLFTUP --> forced eject --> door open/close error
*3) The values of m2stat:
B.upNg=0, FwdTo=1, RevTo=2, Chata=3, OverCnt=4, SwNg=5, SpdNg=6,
Fwd2To=7, Rev2To=8, Sw2Ng=9
*4) The last results of chatter check (compared with the target center):
+8LSB=1, +7LSB=2, +6LSB=3, +5LSB=4, +4LSB=5, +3LSB=6, +2LSB=7,
+1/0LSB=8, -1/0LSB=8,-2LSB=9, -3LSB=a, -4LSB=b, -5LSB=c, -6LSB=d, -7LSB=e, -8LSB=f,
the others=0
*5) Basically the value of eudpzt except for the following case:
In case of eudpzt=1 and door close mode, eudpzt=e
*6) bit0: P_lo1, bit1: P_lo2, bit2: P_elv1, bit3: P_elv2, bit4: P_cg1, bit5: P_cg2,
bit6: P_elv_vol, bit7: P_lod_vol
Claw: It's the part that looks like a claw. It's used to clamp a disc.
CAMRST: Mechanical initialization motion just after resetting
WTLOAD: Loading motion
EJCTON: Ejection motion
SEJPCK: Mechanical motion to check that there is no disc around the loading slot
HLFLOAD: Half loading
DINSRDY: Waiting for disc insertion
LIFTDN: Preparatory motion to clamp a disc after loading
LIFTUP: Preparatory motion to eject a disc
TRAYUP: CAM motor rotation to release the clamped disc from the position where the disc can be rotated
TRYDN: CAM motor rotation to reach the position where the disc can be rotated
CRGOUT: Carriage evacuating motion outside the disc to get ready for elevation motion
CRGIN: Carriage inserting motion inside the disc to get ready for clamping the disc
ELVIN: CAM motor rotation to reach the position where elevation motion can be carried out
ELVOUT: CAM motor rotation to reach the position where disc insertion/ejection can be carried out
EIN_EXP: CAM motor rotation to reach the position where elevation motion can be carried out
CIN_EXP: CAM motor rotation to reach the position where claw's opening/closing motion
DSKFREE: Claw's closing motion to release the clamped disc
DSKLOCK: Claw's opening motion to clamp a disc
CLWCLSE: Claw's closing motion
CLWOPEN: Claw's opening motion
DISCSEL: Elevation motion
FEJCHK: Mechanical motion to check that there is no disc around the loading slot
6.5 SYSTEM MICROCOMPUTER TEST PROGRAM
-
PCL output
In the normal operation mode (the ACC switched ON, the standby mode cancelled), shift the TESTIN terminal to H.
The clock signal is output from the CLKOUT terminal (Pin 39). The frequency of the clock signal is 32.768kHz.