Important
!
Check all connections and systems before
final installation.
!
Do not use unauthorized parts. Use of un-
authorized parts may cause malfunctions.
!
Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi-
cle.
!
Do not install this unit where :
—
it may interfere with operation of the vehi-
cle.
—
it may cause injury to a passenger as a re-
sult of a sudden stop.
!
The semiconductor laser will be damaged if it
overheats. Install this unit away from hot
places such as near the heater outlet.
!
Optimum performance is obtained when the
unit is installed at an angle of less than 60°.
60
°
!
When installing, to ensure proper heat disper-
sal when using this unit, make sure you leave
ample space behind the rear panel and wrap
any loose cables so they are not blocking the
vents.
DIN front/rear mount
This unit can be properly installed either from
“
Front
”
(conventional DIN front-mount) or
“
Rear
”
(DIN rear-mount installation, utilizing
threaded screw holes at the sides of unit chas-
sis). For details, refer to the following installa-
tion methods.
DIN Front-mount
Installation with the rubber bush
%
Install the unit into the dashboard.
After inserting the holder into the dashboard,
then select the appropriate tabs according to
the thickness of the dashboard material and
bend them. (Install as firmly as possible using
the top and bottom tabs. To secure, bend the
tabs 90 degrees.)
Holder
Dashboard
Rubber bush
Screw
Removing the unit
1
Remove the trim ring.
Extend top and bottom of the trim ring out-
wards to remove the trim ring. (When reattach-
ing the trim ring, point the side with a groove
downwards and attach it.)
!
It becomes easy to remove the trim ring if
the front panel is released.
Trim ring
Installation
En
28
Section
07
