Adjusting initial settings
1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1
Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press SOURCE and hold until the clock
appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION
repeatedly to switch be-
tween the following settings:
Clock
FM
(FM tuning step)
AM
(AM tuning
step)
R-SP
(rear output and subwoofer con-
troller)
Use the following instructions to operate each
particular setting.
#
To cancel initial settings, press
BAND
.
#
You can also cancel initial settings by holding
down
SOURCE
until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press
FUNCTION
repeatedly until clock ap-
pears in the display.
2 Press
c
or
d
to select the segment of
the clockdisplay you wish to set.
Pressing
c
or
d
will select one segment of the
clock display:
Hour
Minute
As you select segments of the clock display
the segment selected will blink.
3 Press
a
or
b
to set the clock.
Pressing
a
will increase the selected hour or
minute. Pressing
b
will decrease the selected
hour or minute.
Turning the clock display on or off
You can turn the clock display on or off.
%
Press CLOCK to turn the clockdisplay
on or off.
Each press of
CLOCK
turns the clock display
on or off.
#
The clock display disappears temporarily
when you perform other operations, but the clock
display appears again after 25 seconds.
Note
Even when the sources are off, the clock display
appears on the display. Pressing
CLOCK
turns
the clock display on or off.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press FUNCTION to select FM.
Press
FUNCTION
repeatedly until
FM
appears
in the display.
Initial Settings
En
27
English
Section
08
