Pioneer AVIC-X930BT, Руководство по установке

Страница: 22 / 64

!
The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
Do not cover this area.
!
The semiconductor laser will be damaged
if it overheats, so don
’
t install the naviga-
tion unit anywhere hot
—
for instance, near
a heater outlet.
Parts supplied
Parts marked (*) are supplied with AVIC-
X930BT and AVIC-X9310BT.
The navigation unit Binding screw
(5 mm × 8 mm)
(8 pcs.)
Flush surface screw
(5 mm × 9 mm)
(8 pcs.)
Screw*
(2 mm × 4 mm)
(1 pc.)
Installation using the screw holes
on the side of the navigation unit
%
Fastening the navigation unit to the
factory radio-mounting bracket.
Position the navigation unit so that the brack-
ets screw holes and its screw holes are
aligned, and tighten the screws at three or
four locations on each side.
Use either the binding screws (5 mm × 8 mm)
or flush surface screws (5 mm × 9 mm), de-
pending on the shape of the bracket
’
s screw
holes.
If the pawl interferes with installation,
you may bend it down out of the way.
Dashboard or console
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this navigation
system.
Factory radio-mounting bracket
En
22
Section
03
Installation