Pioneer AVIC-N4/XU/UC, Руководство по обслуживанию

Страница: 14 / 296

AVIC-N4/XU/UC
14
1 2 3 4
1 2 3 4
C
D
F
A
B
E
Resetting the Microprocessor
• Pressing the RESET button deletes the
contents of the system’s memory.
About the data being deleted
The information is erased by pressing the RESET
button or disconnecting the yellow lead from the
battery (or removing the battery itself). However,
the following items are not erased:
• Sensor learning status and driving status
• Memory areas that were memorised manually
• Areas to avoid
• Registered Locations in “Address Book ”
Reset the navigation system
without changing the condition
memory
Pressing the RESET button of the navigation
system lets you reset the microprocessor to its
initial settings without changing the condition
memory.
The microprocessor must be reset under the fol-
lowing conditions:
• Prior to using this product for the first time
after installation.
• If the product fails to operate properly.
• If there appear to be problems with the opera-
tion of the system.
• When changing the combination of the equip-
ment.
• When adding/removing additional products
that connect to the navigation system.
1
Turn the ignition switch OFF.
2
Press the RESET button with a pen tip or
other pointed instrument.
If you have connected other equipment (for
example, Bluetooth adapter) to this navigation
system, be sure to reset that equipment too.
Reset the navigation system to
the initial (factory) setting
When you want to erase memorised settings and
return the navigation system to its initial (factory)
settings, carry out the following operations.
1
Turn the engine ON or set the ignition
switch to ACC position.
2
Press the RESET button with a pen tip or
other pointed instrument.
Some navigation settings and data are not
erased.
RESET button