Pioneer AVIC-N4/XU/UC, Руководство по обслуживанию

Страница: 103 / 296

AVIC-N4/XU/UC
103
5 6 7 8
5 6
7
8
C
D
F
A
B
E
3-12. Language Selection Flag Initialization
3-13. All Memory Clear (Not for service)
• Each status of the “flicker adjustment” and “touch panel outermost circumference correction” is obtained from the
microprocessor to display the result as to whether the monitor is duly adjusted in the production line.
• If both “flicker adjustment” and “touch panel outermost circumference correction” have been duly performed, the
monitor is assumed to be adjusted. You can go to the next inspection by the [8] key.
If either adjustment is found to be missing, the NG screen is displayed to prevent you from going to the next inspection.
• When the system enters into this inspection, language selection will be set to the original setting made at the time
of shipment (i.e. no setting).
* The setting is made to display the screen for selecting the language to be used at the initial boot up after the
shipment out of the factory.
• The setting is made when the system enters into this inspection.
• You can move on to the next inspection by the [8] key on the DVD remote controller.
3-11. Monitor Adjustment Check
• SRAM (application domain) is cleared.
• FLASH (application domain) is cleared.
• Sensor learning level is cleared.
• If SRAM clear is not successful, FLASH will not be cleared.
• After the inspection screen is displayed, the above process is executed by the [0] key on the DVD remote controller.
• The result of the process is displayed.
• Only when everything is OK, you can exit the line inspection process by the [8] key on the DVD remote controller to
go back to the menu screen.