Installation
Notes
!
Check all connections and systems before
final installation.
!
Do not use unauthorized parts as this may
cause malfunctions.
!
Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi-
cle.
!
Do not install this unit where:
—
it may interfere with operation of the vehi-
cle.
—
it may cause injury to a passenger as a re-
sult of a sudden stop.
!
Do not install the display where it may (i) ob-
struct the driver
’
s vision, (ii) impair the perfor-
mance of any of the vehicle
’
s operating
systems or safety features, including air bags,
hazard lamp buttons or (iii) impair the driver
’
s
ability to safely operate the vehicle.
!
The semiconductor laser will be damaged if it
overheats. Install this unit away from hot
places such as near the heater outlet.
!
Optimum performance is obtained when the
unit is installed at an angle of less than 30°.
!
To some types of vehicles, this unit cannot be
properly installed. In such case, use the op-
tional installation kit (ADT-VA133).
Installation using the screw
holes on the side of the unit
%
Fastening the unit to the factory radio-
mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket,
and tighten the screws at 3 or 4 locations on
each side.
1
2
3
5
4
1
If the pawl gets in the way, bend it down.
2
Factory radio mounting bracket
3
Use either truss (5 mm × 8 mm) or flush
surface (5 mm × 9 mm) screws, depending
on the bracket screw holes.
4
Frame
In some types of vehicles, discrepancy may
occur between the unit and the dashboard.
If this happens, use the supplied frame to
fill the gap.
5
Dashboard or console
En
68
Section
15
Installation
Содержание AVH-P2300DVD
Страница 1: ...Owner s Manual DVD RDS AV RECEIVER AVH P2300DVD English ...
Страница 87: ...En 87 ...