27
En
En
g
lis
h
(iii) impair the driver’s ability to safely
operate the vehicle.
•
Never install this product in front of or
next to the place in the dashboard, door,
or pillar from which one of your vehicle’s
airbags would deploy. Please refer to your
vehicle’s owner’s manual for reference to
the deployment area of the frontal
airbags.
•
Consult with your nearest dealer if
installation requires drilling holes or
other modifications of the vehicle.
•
Before making a final installation of this
product, temporarily connect the wiring
to confirm that the connections are
correct and the system works properly.
•
Do not install this product in places
subject to high temperatures or
humidity, such as:
– Places close to a heater, vent or air
conditioner.
– Places exposed to direct sunlight, such
as on top of the dashboard.
– Places that may be exposed to rain,
such as close to the door or on the
vehicle’s floor.
•
Install this product horizontally on a
surface within 0 to 30 degrees tolerance
(within 5 degrees to the left or right).
Improper installation of the unit with the
surface tilted more than these tolerances
increases the potential for errors in the
vehicle’s location display, and might
otherwise cause reduced display
performance.
•
When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
1
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
Before installing
Installation notes
Installation using the screw
holes on the side of this
product
Leave ample
space
5 cm
5 cm
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Truss head screw
Be sure to use the screws supplied
with this product.
•
Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver’s
voice.
•
Be sure to turn off (ACC OFF) the product
before connecting the microphone.
•
Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install the
microphone on the steering column.
The microphone is mounted on the sun
visor.
The microphone is mounted on the
steering column.
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
For installation, contact your dealer or an
authorised Pioneer Service Station for
assistance.
If you have problems operating this
product, refer to this section. The most
common problems are listed below, along
with likely causes and solutions. If a
solution to your problem cannot be found
here, contact your dealer or the nearest
authorised Pioneer service facility.
A black screen is displayed, and
operation is not possible using the touch
panel keys.
→
Power off mode is on.
Installing the
microphone
Appendix
Troubleshooting
Common problems
Содержание AVH-A105DVD
Страница 35: ...35 En English ...
Страница 71: ...37 Es Español ...
Страница 107: ...37 Ptbr Português B ...
Страница 108: ... 2017 PIONEER CORPORATION All rights reserved CRD5025 B RD ...