25
pinnacolopizzaovens.com
TIPS FOR GAS USE
NOTE: If flow limiting device activates, your
oven may not light. If your oven does not
light, the flames will be low and will not heat
properly. Turn tank valve and burner knob off
and wait 30 seconds. After shutting off the tank,
very slowly open tank valve and wait 5 seconds
before lighting.
The oven you have purchased may have some or all the feature
listed below. The locations and appearances of the features
shown here may not match your model.
CONTROL PANEL
A. Battery (for Ignition) Box B. Burner Knob
Any alteration of the product may be potentially hazardous.
Use only low pressure flexible pipes and regulators allowed by
the current regulation. To replace the pressure regulators and
flexible pipes, please refer only to the manufacturer instructions.
Check hose each time before using the oven for nicks, cracking,
abrasions or cuts. If the hose is found to be damaged in any way,
do not use the oven.
Move the oven door holding the wooden handle.
LIGHTING
Check all gas connections for gas leaks before starting your oven.
Do not lean over the oven when lighting. Keep your face and
body at least 50 cm/20-in away from the oven door. When
lighting the oven, the oven door must be open.
The burner control knob must be in the OFF position before
turning on the LPG tank valve.
1. Make sure burner knobs are turned to “OFF”.
2. For gas oven using a propane tank, slowly open the tank valve.
3. Push in and turn the burner knob to IGNITE/HI. The burner
will light immediately. When burner is lit, turn knob to
desired setting.
– If the flame does not light, turn the knob to the “OFF”
position. Wait 3 minutes and try again.
– Do not keep oven on at the maximum power for more than
20 minutes.
– Do not exceed the limit temperature of 426°C/800°F.
– During operation, never disconnect the gas regulator or
other junctions.
– Do not touch external surfaces and the chimney flue during
oven operation.
Pinnacola_Gas_PizzaOven_Manual_BLK.indd 25
Pinnacola_Gas_PizzaOven_Manual_BLK.indd 25
2021-07-02 3:24 PM
2021-07-02 3:24 PM
