Propane (LP) Supply
You must provide the propane gas cylinder(s). Use this
heater only with a propane vapor withdrawal supply
system. Refer to Chapter 5 of the Standard for Storage
and Handling of Liquefied Petroleum Gas , ANSI/NFPA
58. Your local library or fire department will have this
booklet.
- LP Characteristics - Flammable, explosive under
pressure, heavier than air, and pools in low areas.
- In its natural state, propane has no odor, but for your
safety an odorant that smells like rotten cabbage has
been added.
- Contact of propane (LP) gas with the skin can cause
freeze burns.
- Heater is manufactured for use with LP gas only. DO
NOT attempt to convert to any other gas. Such
modifications are dangerous, and will void warranty.
- When heater is not in use, LP cylinder must be turned
OFF.
- Be sure that the LP cylinder is located on a level and
stable surface. The burner should be at least 24 inches
from the floor.
- Do not use this heater in a basement or below ground
level. Propane (LP) is heavier than air, and will always
seek the lowest level. If you suspect a leak, shut off the
valve at the LP cylinder immediately.
Pinnacle Products International, Inc. Tank Top User’s Manual
Page 3
Figure 1
- Product Identification
Safety Information (continued)
Minimum clearance from Combustibles:
Top
5 feet
Sides
3 feet
Front
5 feet
Rear
3 feet
- Operate only on level and stable surfaces.
- NEVER leave heater unattended.
- Keep children and animals away from heater.
- Never operate heater while unattended or sleeping.
- Before connecting the heater to the propane cylinder,
make sure that the heater regulator knob is in the “OFF”
position.
- Always attach the heater in an upright (vertical) position.
Never attach the heater in a horizontal position. This will
lead to dangerous and improper operation.
- NEVER handle an operating or hot heater, as severe
burns may result. Wing nuts and burner heads become
very hot during operation. Do not attempt to adjust
burner position while heater is operating. Always allow
at least 15 minutes of cooling time before handling the
heater.
- Always disconnect and remove the heater from the LP
cylinder after use.
Product Identification
PT-30-TT shown
PT-15-TT shown
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A FUEL SOURCE
Propane
Tank Top Heaters
Model #
Rating
BTU/Hr Max
Operating Time
20 lb. LP cylinder
Ignition
Weight
(Lbs)
Size
(W x D x H)
PT-15TT
15,000
28 hours on HIGH
Match
3 Lbs.
8.5” x 6.5” x 12.5”
PT-15TT-P
15,000
28 hours on HIGH
Piezo
3 Lbs.
8.5” x 6.5” x 12.5”
PT-30TT
30,000
14 hours on HIGH
Match
7 Lbs.
17.5” x 6.5” x 18”
PT-30TT-P
30,000
14 hours on HIGH
Piezo
7 Lbs.
17.5” x 6.5” x 18”
Specifications subject to change without notice
Specifications
