Installation
Simply locate fan in safe, desired position on level
ground, and connect to approved power source.
Operation
This fan is equipped with a 2-speed control
switch.
To start fan
:
1. Be sure the Power Switch is in the middle (OFF)
position.
2. Connect to an approved power source.
3. Make sure area is clear from all obstructions.
4. Push Power Switch to the LOW position and allow
to operate for 10 seconds.
5. Once 10 seconds have passed, you may now
push the Power Switch to the HIGH position.
To turn off the fan, simply return Power Switch to the
middle (OFF) position.
Note: For longer parts life, after 10 hours of con-
tinuous operation, turn fan off for 15 minutes to
allow motor and fan belt to cool.
Maintenance and Storage
1. Inspect your fan before each use. Check all wires
and extension cords, following the procedure out
lined on Page 2 (Safety Information).
2. After use, always be sure fan’s Power Switch is
in the OFF position before unplugging. Use cord
wrap (see page 4) to keep cord off the ground
when transporting fan.
Belt Tightening / Replacement
1. Remove screws from Rear Guard and tilt wheel
(figure 1).
2. Loosen motor nuts, and motor safeguards (locat
ed above and below motor).
3. Remove belt to replace, or adjust motor to tighten
belt (figure 2).
Belt Replacement (cont.)
Pinnacle Products International, Inc. Portable Air Circulator Owners’ Manual
Page 3
NEVER LEAVE A FAN
OPERATING UNATTENDED
Portable
Air Circulator
figure 1
figure 2
Wiring Diagram