PINARELLO Nytro Dust, Руководство пользователя и обслуживание

Страница: 16 / 30

16
7. GENERAL MAINTENANCE AND CARE
Your Pinarello Nytro Dust bicycle is a high quality product. Nevertheless, and precisely for this
reason, it requires continuous correct care and regular maintenance by a specialist to keep it in
perfect operation over the long term.
GENERAL CLEANING AND MAINTENANCE
Dirt, sweat, sea salt and salt from winter roads will damage your pedelec, meaning that the bike
and its components require regular cleaning to protect them from corrosion.
Never clean your bike with pressure washers. These force water into seals and bearings, washing
out lubricants and thus increasing friction on moving parts, causing rapid corrosion and wear.
The better way to clean your bike is to use a gentle flow of water and a sponge or brush. This will
also enable close inspection of the bike, for early detection of signs of wear, fatigue or damage.
The MOST® product line includes all the suitable products for cleaning, care and lubricating your
bicycle.
After cleaning, check the chain, and if necessary lubricate it with the appropriate products.
During cleaning, pay attention to any cracks, scratches, altered paint or
deformations of materials in the components. If in doubt, have the bike
inspected by your trusted Pinarello dealer, who can provide assistance, and
where necessary, replace the damaged components.
Only use products specific to bicycle care. Aggressive, non-neutral degreasers
or chemical detergents could cause cosmetic, surface damage, or worse,
alter the characteristics of important components such as moving parts and
bearings.
The motor action leads to faster chain wear than on regular muscle-powered
bikes. Before each ride, inspect the chain for wear.
Do not apply cleaning and care products or chain lubricant to the brake pads
or discs. This could reduce the braking performance and pose a serious safety
hazard.
CLEANING THE FRONT FORK
After each ride: clean dirt and debris from the upper tubes and dust seals; check air pressure and
inspect the upper tubes for scratches. After every 50 hours of use: service the chainstay at your
authorised Pinarello dealer. After every 200 hours of use: service the spring and damper assembly.
Refer to the fork manufacturer’s manual for more details.
CLEANING THE REAR SUSPENSION
Clean the shock absorber with water and mild detergent. Never clean the shock with pressure
washers. To maintain the high performance, safety and long life of your rear suspension,
periodically check tightening torques, perform routine maintenance on the shock, and service
and grease the linkage system. Refer to the rear shock manufacturer’s manual for maintenance
intervals and procedures. In any case, we advise you to refer to your trusted Pinarello dealer to
carry out maintenance operations.