Pima WRN143, Руководство по установке

Страница: 1 / 8

WRN143/186
Installation Instructions
Инструкция по установке
Instrucciones de Instalación
הנקתה תוארוה
English, Русский, Español,
תירבע
1 Mounting Holes
2 Tamper switch
3 Bus Terminals
4 Bus Cable
5 Hunter-Pro Control Panel
6 Hunter-Pro KEYPAD Terminals 1 Монтажные отверстия
2 Тампер
3 Клеммная колодка BUS расширителя
4 4-х проводной кабель шины BUS
5 Контрольная панель Hunter-Pro
6 Клеммные контакты "KEYPAD"
панели Hunter-Pro
1 Agujeros de Montaje
2 Suiche Tamper
3 Terminales del BUS
4 Cable BUS
5 Panel de Control Hunter-Pro
6 Terminales del BUS Hunter-Pro 1 הילת ירוח
2 רפמט קספמ
3 ירוביח Bus
4 ה יטוח תמצ - Bus
5 לש הרקבה חול Hunter-Pro
6 ירוביח KEYPAD ב - Hunter-Pro
WRN143/186 Wireless Expander
WRN is a FastLink technology wireless expander that allows adding wireless capabilities to the Hunter-Pro Series alarm systems. The
FastLink communication is encrypted using true, 128-bit AES encryption for high level of security.
The WRN can transfer signals from Visonic’s
1 detectors and other peripherals (except remote controls), and PIMA’s RMC remote control
to the control panel, over the bus. The expander supports up to 32 zones/24 key fobs.
The WRN can alert on jamming, and has a back tamper switch.
For enrollment information, see the Hunter-Pro Installation guide (P/N: 4410281).
Technical specifications
 Frequency:
o
WRN143: 433.92MHz
o
WRN186: 868.35MHz
 Current Consumption: 60mA
 Operating Input Voltage: 9-15VDC
 Dimensions: 175 X 12 X 3cm
 Weight: 200gr
 CE Compliance
 Operating Temperature: °C -10 to +50
 Humidity (Max.): 93% R.H., Non-condensing.
Content of the product package

WRN143/186 Ex Bus connector

This guide
Mounting guidelines
 Mount the WRN where the wireless signal is high, and it can be connected to the bus.
 Do not mount the expander inside a metal enclosure or on metalized wallpaper.
 Mount the expander at least 2 meters away from any electrical device that generates noise.
 The expander must not be exposed to direct heat sources, direct sunlight or strong artificial light.
 Contact with spraying or dripping water and aggressive liquids must be avoided.
How to mount and connect the WRN
1. Insert a slotted screwdriver to the niches at the bottom of the expander and remove the backplate.
2. Pass the four bus wires (not supplied) through the backplate and mount it on a flat surface.
3. Connect the bus wires using the supplied connector, making sure to follow the numbering on both the control panel’s KEYPAD
terminals and the expander (terminal #1 on the control panel connects to the same terminal on the expander, etc.).
4. Close the enclosure.
5. Set the expander in the control panel and test it.
1 www.visonic.com
1 Fo
rc
e
B
u
s
2
3
4
5
6
4
WRN
1
2
3