8
SAT-9/TD-900 Installation and Programming Guide
3.2.
Connecting the transmitter
1.
Remove the four fastening screws of the transmitter’s cover and take it off. See
Figure 3 on page 6.
2.
Connect the DPU’s MOLEX/MOLEX harness between the DPU and the transmitter’s
‘Program’ connector. Note the sticker on the transmitter for the direction of the
Molex plug. See the next figure.
3.
Connect the DPU’s USB/MOLEX cable to a USB port on the PC/laptop.
4.
R
un the COMAX application.
5.
Select “TRANSMITTER” from the Account/New drop down list
3
6.
Set the designated frequencies. See section 3.5 on page 11.
7.
Download the frequencies to the transmitter.
8.
Remove the Programming cable from the transmitter.
9.
Connect the SAT-9 to the control panel.
10.
Connect the transmitter’s antenna.
11.
Test the communication between the SAT-9 and the monitoring station: perform a
manual transmission test by pressing the test button on the SAT-9 PCB. See Figure 2
on page 3. If verify fails, check that the Molex connector is connected as drawn on
the transmitter label.
3.3.
The SAT-9 parameters in the COMAX
The SAT-9 parameters are displayed under the ‘General’ tab; they’re divided into 4 tables:
Accounts & formats, PSTN & PGM parameters, transmission properties and ACKs. All
parameters are described in the next sections.
3
Please refer to the COMAX guide for more information on programming,
COMAX
Long range Radio
transmitter
DPU
Wire harness
USB/MOLEX cable