Pima SAT-9, Инструкция по установке и программированию, Страница: 6 / 12

6 SAT-9/TD-900 Installation and Programming Guide
Figure 3. The SAT-9 diagram
Figure 4. The SAT-9 and transmitter wiring diagram
6.
If the SAT-9 is to be used as a backup the PSTN line, connect the line wires to the
LINE terminals.
7. If the SAT-9 is to be used as the primary communicator (i.e., the control panel has
no access to a telephone line), shortcut the PGM input to the GND terminal.
8. If the SAT-9 will be triggered by the control panel, connect the PGM input to a
control panel’s output and connect the alarm system’s (-) to SAT-9’s (-)
To 12V backup battery
Transmitter’s
antenna
connector
SET:
to the control panel’s
telephone line-in
Manual test button
SAT-9 programming
cable connector
+
-
JP4
JP3
PGM
LINE
TEST
SAT-9
SET
GND +
-
Transmitter’s
box screw
LINE: phone line-in
Transmitter’s
box screw
Transmitter’s
box screw
Transmitter’s
box screw
Mounting holes
PGM input
Transmitter’s wire
harness
JP4
JP3
PGM
LINE
TEST
SAT-9
SET
GND +
-
Second frequency
triggering connector
Long range Radio
transmitter