Troubleshooting and Tests
24
Pressing ENTR will end with the system displaying each valid message. This
mode is frequently used to check all installed detectors. The detectors are
triggered one by one and after ‘walking through’ all of them, the history log
(memory) holds all their signals along with their measured RSSI level.
Tamper Test
→
NEXT
SERVICE
to start tamper test
Pressing NEXT will end with the system displaying only the tamper signals
received from the detector(s). This mode is most useful when deciding on the
best location for a specific wireless detector.
To execute the test, open the detector’s case and hold down the tamper switch.
Now, each time the tamper switch is released, a Tamper Signal is transmitted by
the detector and the appropriate data is displayed on the LCD.
Example Display for Test Mode:
W
1 2 : 3 4
- - - - - - - - - - -
-
- - - -
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
L I V I N G
R O O M
1 0
Z 1 2
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
g
Signal received from zone 12 (programmed name is Living Room) with RSSI level of 10
(where 10 is the best score and 1 is the worst)
