HUNTER-PRO 32 User Manual LED Keypads
13
Remote Control via Touch-tone Phone
The alarm system can be remote-controlled via any touch-tone telephone,
including cellular phone. The system can be controlled from the moment
communication is established, whether the system called the telephone, or
when initiated by the user as following described.
1.
Dial the telephone number that the system is connected to
2.
Wait for the system’s confirmation tone (a long tone followed by two beeps)
3.
Enter the Master Code (note
NOT
to enter the code before the end of the
confirmation tone)
4.
Wait a few seconds until the alarm system confirms its status, using one of
the two following tones:
Continuous tone:
System is disarmed
Beeping sound
:
System is armed
NOTES:
The system will not identify commands from the telephone while sounding the
confirmation tone. It is important to wait until the confirmation tone is finished
before pressing the telephone keys that control the system.
The alarm system confirms the command was received by two short beeps.
There are two modes for controlling the system, as set by the installer:
MODE A - One touch control
5.
Execute command by single key pressing on the phone.
The following table includes system’s commands by phone keys:
Phone key:
Function:
1
Arm the system
2
Disarm the system
4
Arm the system in “Home 1” mode
5
Switch on the Relay
6
Switch off the Relay
7
Arm the system in “Home 2” mode
8
Listen in (only available with a MIC-200 installed)
0
Disables siren and dialer (in case of an alarm)
