HUNTER-PRO Series & CAPTAIN 8 User Guide
9
2.1
Arming
•
To arm your system, enter a user code (see section 9.4 for restrictions) or the Short code
(a code programmed by the Installer. See section 9.12).
•
If no zone is open and there are no faults, the Exit delay countdown starts, the keypad
buzzer sounds beeps and the green ARMED LED flashes
.
You can now exit the premises
and close the door behind you
1
.
•
When the Exit delay ends, the system becomes armed: the green ARMED LED stops to
flash and stays on, the beeps stop, the message “System Armed” is briefly displayed and
then the date and time are displayed.
2.1.1
Via the keypad
User code
...
•
The Exit delay time span is set by the Installer.
2.1.2
Fast arming
until the Exit delay starts
-OR-
Short code
...
•
Fast/single keystroke arming must be enabled by the Installer.
•
To set the Short code, see section 9.12.
2.2
Disarming
User code
…
•
To disarm the system, enter a user code.
•
If an “Access denied” message is displayed, the user may be trying to disarm it outside
her/his “Disarming time frame”. See section 9.5
2.2.1
With the DURESS code
DURESS code
…
•
The DURESS code is a code to be used in threat situations, where you are being forced
to disarm the system. Hence, the code can be used only for disarming.
•
Entering the DURESS code disarms the system and sends a silent alarm to the Monitoring
Station (if you are subscribed to) and your phones.
•
To set the code, refer to section 9.3.
1
The Exit delay countdown can start immediately as soon as the final door is closed. Refer to the Installer.
Sy s t e m Ar me d !
1
1
1
1
Sy s t e m Ar me d !
Di s a r mi n g . .
Di s a r mi n g . .
