Installation
Operating Manual PIT gb
1004627-EN-04
| 23
5. Loosen the threaded ring of the control element that is to be exchanged and remove
the threaded ring (see figure).
1. Remove the control element on the front of the PIT gb and insert the part of the new
control element.
The control element has a stud on its side to secure it against twisting. The stud must
be positioned correctly when inserting the control element.
2. Screw the control element to the threaded ring again using 1,2 Nm (see figure) and ap-
ply the printed circuit board again.
a
Make sure that the strands are not damaged, crushed or twisted here.
3. Screw the printed circuit board to the fixing screws with 1,8 Nm (see figure).
