Uneven flame when cutting torch is used
during cutting
1. Set oxygen pressure and acetylene / LPG gases
pressure regulator gas flow / gas pressure either to high
or too low, adjust by manipulating gas control valves of
cutting torch.
2. The Nozzle and Tip orifice has been obstructed.
3. The Nozzle and Tip has became over heated.
4. Slag particals have logged in the Nozzle and Tip orifice
during cutting operation.
Precaution
1. Set oxygen and acetylene / LPG gases pressure as per
manual.
2. Check the nozzle and tip seal free from dent & scratch
marks.
3. In case due to any reason nozzle and tip and holder /
shank getting over heated, dip the holder / shank of
cutting torch with the nozzle and tip in the water. Reuse
the blowpipe safety.
Mfd. by:
Rails Engineering Works
21, Balaji Industrial Estate,
Hanuman Nagar, Akurli Village,
Kandivali East, Mumbai 400 101 MH. INDIA
Tel.: +91 22 660 47 000
TECHNICAL DATA
Nozzle Oxygen LPG
Acetylene Cut (M.S.)
bar
psi
bar
psi bar
psi
mm
inch
1/32”
1.5
20
0.10 1.4
0.15 2
6
¼”
3/64”
2.0
30 0.10 1.4
0.15 2
12
½”
1/16”
3.0
45
0.10 1.4
0.15 2
50
2”
5/64”
4.0
60
0.2
3
0.2
3
100
4”
3/32”
4.0
60
0.2
3
0.2
3
150
6”
1/8”
4.5
65
0.2
3
300
12”
Swage
type nozzle
Detachable
type nozzle
Also available : Gas Torch
NOW
WITH
MARK
