PikeSystems Pike-1000, Руководство оператора

Страница: 14 / 18

14
Cl Maintenance
WARNING!
To avoid accidents, always remove the
battery and disconnect the charger from the power supply.
Never immerse the sprayer in any liquid for cleaning.
The sprayer can only be operated normally if it's cleaned and
preserved after each use. When cleaning, use the appropriate
cleaning solution.
WARNING!
NEVER use any solvent that have a flash
point lower than 73.5°F (23°C).
Clean the Container
1. Stop the sprayer and remove the battery. Press the On/Off
switch so that the material inside the spray gun assembly
flows back into the container.
2. Unscrew the container. Discard any unused solvent to its
original container.
NOTE: . Discard appropriately according to regulations or
save in a separate container.
3. Pour a small amount of water into the container. Clean
the container and properly dispose of the dirty water.
Refill the container with clean water.
4. Reattached the container on the sprayer. Insert the battery
and spray the clean water through the sprayer in a safe
area. Refill and repeat spray process, until the water
being sprayed is clean and clear.
5. Stop the sprayer and remove the battery. Press the On/Off
switch so that the material inside the spray gun assembly
flows back into the container.
Clean the Housing and the Parts
1. Remove the container and pour out any remaining
solution.
2. Turn the quick release knob to the unlock position and pull
out the spray gun assembly (Fig. 23).
3. Turn the suction tube clockwise and pull out to remove the
seal and the suction tube (Fig. 24).
4. Unscrew the tip collar, remove the spray width control
lever + ring, air cap and the nozzle tip (Fig. 25).
5. Dip a clean cloth in water or proper solvent, and clean all
the disassembled parts, the spray gun assembly, and the
motor housing.
6. Double check the suction tube. If it's blocked, use the
supplied cleaning brush to clean through the inlet and the
outlet (Fig. 26).
7. If needed, use the needle clean out tool to clean the
nozzle tip (Fig. 27).
Fig. 23
Quick release knob
Spray gun
assembly
Fig. 24
Seal
Suction tube
Fig. 25
Air cap
Nozzle tip
Spray width
control lever
+ ring
Tip collar
Fig. 26
Suction tube