PikeSystems Pike-1000, Руководство оператора

Страница: 11 / 18

11
To change the nozzle tip, follow the instructions below:
1. Make sure the tool is switched off and the battery is
removed from the compartment.
2. Unscrew and remove the tip collar slowly, be careful that
the small parts may fall out, and remove the nozzle tip
inside (Fig. 13).
2. To spray in an upward direction, the angled end of the
suction tube should be pointing toward the rear of the
sprayer (Fig. 12).
3. Assemble the desired nozzle tip by aligning the 4 tabs on
the tip with the notches on the sprayer and inserting the
middle needle in the middle hole of the nozzle tip. Press
firmly until the nozzle tip sit securely in position. Replace
the tip collar and tighten securely (Fig. 14).
WARNING!
Never tilt the sprayer at an angle greater
than 45°. Material could get into the turbine and damage
the sprayer.
Change the Nozzle Tip
The machine comes with 3 nozzle tips. To use the
sprayer to apply disinfectant or chemical, use only the
red nozzle. Discard the others to prevent confusion.
•
White
–
1.5 mm orifice. Pre-assembled in the gun
•
Black
–
1.8 mm orifice. Packed separately
•
Red
–
2.2 mm orifice. 50 micron spray for use with
various chemicals and disinfectants approved for use
through sprayers per label guidelines and EPA
registration.
Adjusting the Spray Patterns
The spray pattern shape can be adjusted by turning the ears
of the air cap to either the vertical, horizontal, or diagonal
positions. The positions of the air cap and the corresponding
spray pattern shapes are illustrated below (Fig. 15).
Test each pattern and use whichever pattern is suitable for
your application.
Fig. 11
Suction tube
pointing
forward
Fig. 13
Nozzle tip Tip collar
Fig. 14
Notch New nozzle tip
Tab Tip collar
Suction tube
pointing to
rear
Fig. 12