PIKA Harbor Flex SB10p, Руководство по эксплуатации

Страница: 18 / 27

16 Harbor Smart Battery Operation Manual M00017-02
Blackstart
WARNING: DURING A POWER SEARCH, HARBOR CREATES DANGEROUS
VOLTAGE AT THE REBUS TERMINALS. To prevent Power Search, always
turn the Harbor front panel switch to “OFF” before performing service.
To prevent Harbor from performing a Power Search, turn the switch on the front cover of Harbor
to the “Off” position.
Blackstart
Under normal operation, with Harbor enabled and the Islanding Inverter interacting with the utility
grid, Harbor will source and sink power to the REbus nanogrid as defined by the Operational
Mode. Upon loss of utility power, Harbor will immediately begin providing backup power to the
REbus Nanogrid.
However, if Harbor is disabled or the front panel switch is “Off” at the time at the utility grid loses
power, then the REbus nanogrid will de-energize and all REbus devices will power down. In this
state, no REbus devices can source or sink power and the Islanding Inverter cannot provide
backup power to the AC Critical Loads until the user manually performs a Blackstart.
To Blackstart, turn the switch to the ON position. If Harbor is enabled and the battery has
sufficient charge, the front panel LED will light green. After initialization is complete, then Harbor
will automatically energize REbus and begin supporting REbus and AC loads, and charging from
other sources if available (such as PV Link).
If the front panel LED lights red, this means Harbor is disabled. You must perform a Manual
Enable. Harbor cannot energize the REbus nanogrid until it is enabled using this sequence.