p i g t r o n i x . c o m
|
15
14 |
p i g t r o n i x . c o m
E c h o l u t i o n 2 | E c h o l u t i o n 2 D e l u x e
E c h o l u t i o n 2 | E c h o l u t i o n 2 D e l u x e
TOUCH SWITCHES — DELAY LINE I/O
SHORT PRESS
cycles between:
TRAILS
- old echos “spill over” after bypass for
smooth transitions.
LISTEN
- echo material is recorded (although not
heard) while in bypass.
NORMAL
- normal bypass (no LEDs lit up).
LONG PRESS
turns on DRY KILL - this cuts out the analog clean signal from the mix.
DRY KILL is useful for special effects or when using a parallel effects loop on an amp or when
adding delay to a full mix
BOOT OPTION: DRY KILL DURING BYPASS -
enables Dry Kill when
Engage is off.
This can be toggled by HOLDING the DELAY LINE I/O switch during the power-up
procedure of the E2.
UPPER BUTTON
TOUCH SWITCHES — SPECIAL FUNCTIONS
SHORT PRESS
turns on
REVERSE
– reverses tape in delay mix
LONG PRESS
turns on
DUCK
– lowers delay mix with higher input signal
ADJUSTABLE FILTER CUTOFF FREQUENCY
The default filter, LP filter, and Tape filter can have different settings for each preset. To change
the corner frequency of the currently enabled filter, Press and hold both the Filter Selection and
Bypass Selection Touch Switches, and turn the Speed knob while still holding down the switches.
Factory Settings : Default Filter = Fully CW
LP Filter = 11 o’clock
Tape Filter = 9 o’clock
Any changes made to these settings can be saved to the current Preset using the Preset Encoder
( See ‘Preset Saving’ in the ‘Presets’ section).
BOOT OPTION: GENERATE MIDI CLOCK -
Allows the E2 to generate
its own MIDI Clock.
This can be toggled by HOLDING the SPECIAL FUNCTIONS switch during the
power-up procedure of the E2.
LOWER BUTTON