Pifco PUV011, Инструкция по эксплуатации

Страница: 8 / 11

15 14
• Do not clean the vacuum cleaner, components or accessories using petrol
or any other flammable liquid or solvents, etc.
• Clean only the outside of the vacuum cleaner.
• Use only a moist cloth and mild detergent for cleaning the vacuum cleaner,
components and accessories.
• After cleaning, wipe off the moisture on vacuum cleaner, components and
accessories with a dry cloth.
• Do not place accessories, tools or components in a dishwasher.
BRUSH ROLL
You should check your cleaner’s brush roll and drive belt regularly for wear or
damage. You should also clean the brush and brush ends by removing string,
hair and carpet fibres. These can wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any debris that has accumulated under
the brush cover.
Turn off vacuum, unplug from electrical outlet and lace vacuum upside down.
1 Remove the six screws as shown with a small Phillips screwdriver.
2
Lift off brush cover. It will unclip the securing lug on the front of the housing.
3 Grasp floor brush at both ends and remove by lifting out.
4 Clean string, hair and other debris from floor brush, motor pulley, and drive belt.
Check air passageway for obstructions. Remove debris from this area.
5 When finished cleaning, reposition floor brush and drive belt. Turn floor brush by
hand several times in the direction of the motor pulley. If properly installed, the
drive belt will align itself on floor brush.
Then replace the brush cover and re-install the six screws.
Maintenance Replacing The Drive Belt
1 2
For your convenience we have included an extra drive belt with this vacuum.
Make sure the vacum is switched off and unplugged first.
Check the drive belt carefully for wear, cuts and stressed areas. If the drive belt
appears worn, you will need to replace it. To remove the drive belt, read the
instructions and follow the drawings below:
1 Grasp the old drive belt and remove from motor shaft. Discard old drive belt.
2 Loop new drive belt over motor shaft and stretch other end over floor brush in
the space provided between the bristles.
3 Place ends of floor brush down into slots on sides as shown. Turn floor brush by
hand several times in the direction of the motor shaft. If properly installed, drive
belt will align itself on floor brush.
4 Replace brush cover and six screws.
1 2 3 4
3
5
4